StabilRoad® technology was developed in Germany
StabilRoad® stabilization additive is a whitish powder made from 100% natural minerals with no synthetic chemicals. The chemical effect of the stabilization additive consists in increasing the hydration processes of the cement. Cement hydration is a chemical process in which cement particles react with water to form new bonded compounds that make up the skeleton of concrete. As a result of crystallization, water-insoluble compounds are formed, which make the treated layer non-absorbent. By increasing the hydration of the cement, the number of cracks decreases, the elasticity, compressive and tensile strength of the stabilized surface increases, and the material becomes water and cold resistant. It is possible to stabilize both the base layers of the soil and the lower layers. The surface is also no longer damaged by salts, oils and acids.
The properties of a surface stabilized with StabilRoad® stabilization additive can be compared to concrete. Such properties give the processed layer good prerequisites for longer-term resistance even in a humid location.
By using StabilRoad® stabilization additive in the appropriate ratio with the amount of cement, the risk of cracking is significantly reduced. Soils treated only with cement become very stiff and the risk of cracking of these surfaces is very high.
Using StabilRoad® stabilization additive and special technique, we can significantly speed up the construction process, reduce the cost of the work, and at the same time achieve a very strong stabilized surface.
FAQ
What are the biggest advantages of StabilRoad® technology?
The biggest advantage of StabilRoad® technology is making the soil resistant to water, salt, acid, oil and freezing. In addition, it provides the necessary properties such as compressive strength, load-bearing capacity and elasticity. The use of StabilRoad® additive makes the soil durable and long-lasting.
For which soils can StabilRoad® additive be used?
StabilRoad® additive can be used on almost any type of soil. It works with most soils that can be found in different climate zones around the world. Therefore, the StabilRoad® additive is very versatile and widely applicable.
What soil materials need to be added with StabilRoad® additive?
Unlike conventional road construction technology, there is no need to excavate and dispose of existing soil such as sand, gravel or crushed stone. Therefore, there is no need to purchase and deliver new and expensive quarry materials. This makes StabilRoad® technology very environmentally friendly and cost-effective.
How long does soil stabilized with StabilRoad® additive last?
Soil stabilized with StabilRoad® additive lasts for several decades, as its structure is similar to concrete and continuously strengthens over time. StabilRoad® technology ensures long-lasting, durable and worry-free use and at the same time is completely maintenance-free.
How much asphalt wear layer is required for StabilRoad® technology?
In the case of StabilRoad® technology, a 4-6 cm asphalt wear layer is sufficient. Therefore, the StabilRoad® additive is a very practical, efficient and cost-effective solution.
How long does the stabilization process with StabilRoad® technology take?
It is possible to stabilize 5000-10000 m2 of surface in one day and with one set of techniques. The stabilized road can be opened to traffic after 24 hours.
The exclusive right of the StabilRoad® technology international trademark belongs to StabilRoad Holding OÜ, which is registered in the Republic of Estonia. StabilRoad Holding OÜ is the official representative of StabilRoad® technology and products worldwide.
We are represented in more than 50 countries
Technical information
• WIPO
• OAPI
• EUIPO
• Australia
• Kyrgyzstan
• Oman
• United Arab Emirates – 46
• United Arab Emirates – 47
• Russian Federation
